Qty:

Splitters, Attenuators

The Wilson 859901 signal splitter allows you to split the signal from an amplifier to up to 4 internal antennas with negligible signal loss. The splitter is dual band/iDEN, and so will work with all the amplifiers on our site.

This 2-way splitter allows you to drive two interior antennas from a single amplifier/repeater. Because you are splitting equally the signal each antenna will receive is 1/2 of the original signal. This equates to about 70% of the coverage distance when compared to driving a single antenna. You should use this splitter if the areas you wish to cover are approximately equal in area.

Connections:
The splitter has N Female connectors. Typically a 2ft cable is used to connect the splitter to the amplifier. Any cable length can be used, but the total cable length in the system should be kept to a minimum to minimize attenuation.

Lengths of coaxial cable can then connect the splitter to the internal antennas.

Additional Information:
Frequency: 800MHz, 1900MHz, Dual Band, iDEN
Impedance: 50 ohm
Connector Type; N Female
Signal Split Ratio: Equal
Loss: Both ports -3dB