Qty:

Splitters, Attenuators

The Wilson 859906 signal splitter allows you to split the signal from an amplifier to up to 20 internal antennas with negligible signal loss. The splitter is dual band/iDEN, and so will work with all the amplifiers on our site.

For use in signal distribution systems to split the amplified signal to up to 20 inside antennas with minimal signal loss. Features low-loss signal throughput with one -6dB tap.

This 2-way splitter allows you to drive many interior antennas from a single amplifier/repeater. The signal is not split equally - 75% of the signal is sent through one side, 25% through the other side. You can use this splitter if you wish to cover two areas which are different in size. Alternatively when used with other splitters it can be used to create a system of many internal antennas with customized coverage areas.

It has a weatherproof case suitable for indoor or outdoor use.

Connections:
The splitter has N Female connectors. Typically a 2ft cable is used to connect the splitter to the amplifier. Any cable length can be used, but the total cable length in the system should be kept to a minimum to minimize attenuation.

Lengths of coaxial cable can then connect the splitter to the internal antennas.

Additional Information:
Frequency: 800MHz, 1900MHz, Dual Band, iDEN
Impedance: 50 ohm
Connector Type: N Female
Signal Split Ratio: 75% / 25%
Loss: -1.5dB / -6dB