Qty:

Splitters, Attenuators

The Wilson 859928 signal splitter allows you to split the signal from an amplifier to up to 4 internal antennas with negligible signal loss. The splitter is 1900MHz, and so will only provide 1900MHz signal to the antennas. It is most commonly used with the Wilson 801365 1900MHz amplifier.

This 2-way splitter allows you to drive two interior antennas from a single amplifier/repeater. Because you are splitting equally the signal each antenna will receive is 1/2 of the original signal. This equates to about 70% of the coverage distance when compared to driving a single antenna. You should use this splitter if the areas you wish to cover are approximately equal in length.

Connections:
The splitter has N Female connectors. Typically a 2ft cable is used to connect the splitter to the amplifier. Any cable length can be used, but the total cable length in the system should be kept to a minimum to minimize attenuation.

Lengths of coaxial cable can then connect the splitter to the internal antennas.
 

Additional Information:
Frequency: 1900MHz
Impedance: 50 ohm
Frequency detail: (up/down) 1850 - 1910 MHz / 1930 - 1990 MHz
Connector Type: N Female
Signal Split Ratio: Equal
Loss: Both ports -3dB