In-Building Amplifiers for PANTECH Breeze C520
The Wilson Cellular Amplifier / Repeater has a better
receiver than what's in your cellphone. Its advanced electronics are very
sensitive and able to receive small signals which would go undetected by most
cellphones. It also has a better transmitter with double the power of your
cellphone. This allows your voice to be heard by distant cell sites, increasing
coverage up to 50 miles or more.
The 60dB Amplifier/Repeater is very powerful. It can provide in building
coverage in areas where the outdoor (donor) signal is extremely weak or provide
large in building coverage when the outdoor (donor) signal is fairly strong. In
cases where the donor signal is very strong, you may have an area around the
indoor antenna (circle - 10` radius) that you may not be able to use your phone
due to the strong signal strength.
A cellphone using our amplifier is safer and will use less battery power because
the phone thinks it's much closer to a cell site than it actually is. Phones
vary their power output based on their proximity to cell sites. Therefore, your
phone transmits less power - resulting in safer use and longer battery life.
This Amplifier-Repeater greatly improves signal strength inside a building when
using your cellular phone. It does this without a physical connection to your
phone, allowing you to walk freely during a call. It even allows multiple phones
to be used simultaneously.
The signal is received by the outside antenna from the cell site. It is then
amplified and repeated to your phone through the inside antenna. When the phone
transmits it is received by the inside antenna. It is then amplified/repeated to
the cell site through the outside antenna. Wireless operation - no physical
connection to cellular phone.
Wilson Cellular Amplifiers extend cellular services in poor coverage areas by
amplifying both transmit and receive signals. The amplifiers reduce problems
with signal fades and dropped calls while improving voice quality, service range
and access. These multi-mode amplifiers are designed to offer a cost-effective
solution for use in buildings. Wilson Cellular amplifiers are network compatible
and enhance the cellular phone user`s satisfaction without comprising the
operation of the cellular system.
Advanced Electronics Receive & Transmit Better Than Your Cellphone*
Wireless Operation - No Physical Connection to Cellphone
Allows Multiple Phones to be Used Simultaneously
Significantly Increases Your Cellphone's Range on Send & Receive
Safer Than Using Your Cellphone Without An Amplifier**
Extends the Life of Your Cellphone's Battery**
FCC Type Accepted
When designing your system, please be sure to allow for 70' of separation
between the interior and exterior antennas (20' which must be vertical).
Compatible with all 800MHz Cellular providers (CDMA, TDMA, GSM, Analog). For
example, most Verizon, AT&T TDMA, Alltel, US Cellular and many more
Not compatible with 1900MHz PCS (AT&T GSM, Sprint PCS, T-Mobile, Qwest)
Not compatible with iDEN (Nextel, Southern LINC, Mike)